UM-5DL A&B-Scan Ultrasonic Thickness Gauge meter tester
UM-5DL Technical Specifications
If the ordinary thickness gauges are incompetent in the rough applications. Please turn to our UM-5, which will maximize measurement performance for challenging applications and provide you with the cost-effective measurement solutions.
The ordinary ultrasonic thickness gauge with the principle pulse/echo method could do the test by the following two conditions.
1. The first underside echo must be higher than the gate. (The height of the electrical level of the gate is unadjustable)
2. No other noise waves before the first underside echo are higher than the gate. (Otherwise, we will get the thickness where the noise wave are produced)
For some conditions, the above situations could not be satisfied,for example, the highly corrosive near surface, coarse-grain materials (e.g. cast iron),aluminum, small diameter pipes, super thin sheet, super thick plate, rough surface, nonuniform inner structure, defect contained workpiece, lamination and so on which could not be tested by the ordinary gauges.
UM-5 will solve the above problems easily：
1. Make the first underside wave higher than the gate by adjusting the gain and height of the gate。
2. Invalidate noise waves before the first underside wave by the function of blanking.
MAIN FEATURES OF UM-5DL
(Live Color A-Scan)
user could directly see the color waveform of the ultrasonic sound (or A-scan) on the screen, which is quite important for the occasions that we need to check the correctness of the testing results. Many cases will cause wrong testing results or even no readings. We could find the causes easily through the A-scan. Adjust the three parameters of GAIN, BLACKING, GATE, and then we will get the right readings.The uses for waveform: testing the correctness of thickness readings, finding out the causes of impacting the testing, and adjusting the parameters to solve the problems.
UM-5 series thickness gauge has time-base B-scan function. Move the probe along the workpiece surface, then the cross-sectional profile of the workpiece display, use for observe the underside contour of the workpiece.
When remove the probe from workpiece, it could be automatically capture a minimum value of the B-scan image, and indicate the position of the minimum by a red triangle. You can see any point thickness value of the B-scan image by moving the pointer.
Pulse echo with dual element transducers
0.5 to 508mm(0.02" to 20.00"),
depending on probe,material and surface condition
Unit and Display Resolution
V- Path Correction
±0.05mm (25mm below)
±0.2% H (100mm above)
±0.5% H (100mm above)
H is the height of testing object
2.4" color OLED, 320 X 240 pixels
Measurement Update Rate
Two 1.5V AA batteries
Two 1.5V AA batteries，Approximately 36 hours.
After 5,10,20 minutes of non-action period
-10℃～+50℃，available for as low as-20℃ on request
280g including batteries
UM-5 thickness gauge unit
Standard Probe (PT-08)
Two 1.5V AA batteries
Numerous special probes；step calibration；
Couplant and Hight temperature Couplant
Edited by Cara